User's Manual 7. Performing Advanced Operations
137 C450HD IP Phone
7.13.2 Making Sure BToE is Correctly Installed
This section shows how to make sure Better Together over Ethernet is correctly installed.
To make sure BToE is correctly installed:
1. Click the AC (AudioCodes) taskbar icon; the following menu pops up:
Figure 7-14: Popup Menu
2. Select the About… menu option to verify the DLL and BToE version:
Figure 7-15: About AC BToE
7.13.3 Configuring the BToE TCP Port
You can opt to configure a different BToE TCP port to the default 9999, depending on the
requirements of your enterprise. For example, you may decide to change the BToE TCP port to
5000 because your enterprise is using the default port of 9999, and 5000 is available. This
feature therefore provides enterprise administrators with more freedom in network administration.
Note: If you decide to change the default BToE TCP port, you must update both the
PC/laptop and the phone with the new BToE TCP port number.
To change the BToE TCP port on the PC/laptop side:
1. Click the AC (AudioCodes) taskbar icon; the menu shown in Figure 7-14 pops up.
2. Select Disconnect in the popup menu and then select Configuration > TCP Port.
Figure 7-16: TCP Port
To Next Page
Loading...
