Mounting Instructions
Installation Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-INSTALL/DGB Rev. I, 2014-04-01,
Autronica Fire and Security AS
Page 14
5. Mounting Instructions
5.1 Introduction
This following chapters deal with the mounting of:
Fire Alarm Control Panel BS-420 / Controller BC-420
Operator Panel BS-430
Repeater Panel BU-BV-420 (Fire Brigade Panel / Information
Panel)
Loop Panels (Information Loop Panel BV-110 and Fire Brigade
Loop Panel BU-110)
Power Cabinet BP-405
Power Units BPS-405 and BPS-410
The following is delivered together with the system units:
Fireman’s key (delivered with all system units, except for BC-420
and BP-405/BPS-405/BPS-410)
Unbraco key (to lock/unlock the front panel) – (not delivered with
BP-405 /BPS-405/BPS-410)
Plastic cap to cover the key hole (Repeater Panel only; when
Repeater Panel BU-BV-420 is to be used as an Information Panel)
11 Rubber glands for entry of external cables
Text foils
A general description of flush mounting Repeater Panel BU-BV-420
and Operator Panel BS-430 in a wall is described in a chapter 5.10.
For information on mounting the Controller Rack BC-440, refer to
separate datasheet.
This product contains static-sensitive devices.
Always use an antistatic wrist strap / earth bracelet to avoid any
electrostatic discharge.
To Next Page
Loading...
Need help?
General