Connecting External Cables
Installation Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-INSTALL/DGB Rev. I, 2014-04-01,
Autronica Fire and Security AS
Page 38
9.3.1 Voltage Selection 115/230VAC on the BPS-405
Make sure that the mains power is not connected.
Use a screwdriver to slide the switch to the correct position
according to the appropriate voltage (115/230VAC).
9.3.2 115/230VAC Voltage BPS-410
Note:
The BPS-410 Power Unit 24VDC/10A is delivered as two separate
part numbers:
116-BPS-410 for 230VAC
116-BPS-410/115 for 115VAC
Make sure to use the correct unit according to the appropriate
voltage (115/230VAC).
To Next Page
Loading...
Need help?
General