Pre-installation
Installation Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-INSTALL/DGB Rev. I, 2014-04-01,
Autronica Fire and Security AS
Page 9
2. Pre-installation
2.1 Location
The Fire Alarm Control Panel or Operator Panel must be located in, or
nearby, the entrance according to local regulations and in consultation
with the fire brigade.
Repeater Panels (Fire Brigade Panels and Information Panels),
Controllers and Power Cabinets must be placed according to local
regulations and in consultation with the fire brigade.
2.2 Environmental Requirements
For information on environmental requirements for AutroSafe
equipment, refer to separate datasheets.
2.3 Mounting Height / Space Requirement
To ensure optimal readability of the Fire Alarm Control Panel's
display, the recommended mounting height of this cabinet top is
approximately 175 cm above the floor. Other panels should be
mounted accordingly.
To Next Page
Loading...
Need help?
General