Autronica Autro Safe User Manual

Installing I/O Modules
Installation Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-INSTALL/DGB Rev. I, 2014-04-01,
Autronica Fire and Security AS
Page 52
10.3.3 Removing
 Ensure the panel is not powered.
 Unplug the connection block.
 Use a screwdriver to carefully
lift the topmost module upwards
(1) until the connector between the
modules is free.
 Use the screwdriver to slightly
bend the left side of the
fastener towards left (2) until
it loosens, then remove (3) the
module.
 If necessary, continue removing
the next one in the same way.
10.3.4 Before Connecting Cables
 Before connecting cables, make sure that the mains power is not
connected.
POWER OFF!
10.4 Data Sheets - I/O Modules
The AutroSafe User Documentation provides data sheets for I/O
modules, including a short description of the I/O module, its
application, plus technical specifications and cabling.
!

Autronica Autro Safe Specifications

General

Brand	Autronica
Model	Autro Safe
Category	Smoke Alarm
Language	English