About This Documentation
10 Installing and Configuring the Avaya S8700 Series Media Server
For the physical installation and cabling of the hardware, see the Quick Start for Hardware
Installation: Avaya S8700 Series Media Server (555-245-703). Use the remaining sections of
the document in the sequence they are presented. If certain components are not to be installed,
skip the procedures for those components. You install and configure the media server
components using information in the following sections:
● Configuring the SNMP modules in the UPS on page 30
● Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 34
● Configuring the media server on page 42
● Configuring the media server on page 42
● Translating the IPSIs on page 51
To complete the installation, you install the media gateways, using sections in Installing the
Avaya G650 Media Gateway (03-300144).
Connect the system to the customer’s network using information in Connecting to the IPSIs
on
page 57.
Complete the installation using information in the following sections:
● Completing the installation administration on page 71
● Testing the media server installation on page 83
● Accessing the media server on page 95
If problems occur during the installation, use Troubleshooting an installation
on page 105 to try
to resolve them.
Conventions
This section describes the conventions that we use in this book.
General
We show commands and screens from the newest Avaya Communication Manager and refer to
the most current documentation.
Physical dimensions
All physical dimensions are in English units followed by metric units in parentheses. Wire gauge
measurements are in AWG followed by the diameter in millimeters in parentheses.
To Next Page
Loading...
Need help?
General
