Avaya S8100 Series Installing And Configuring

Connecting to the IPSIs
66 Installing and Configuring the Avaya S8700 Series Media Server
3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Note: Use Help to obtain syntax guidelines for these commands.
● Enter set vlan priority 6
● Enter set diffserv 46
● Enter set vlan tag on
● Enter set port negotiation 1 disable
● Enter set port duplex 1 full
● Enter set port speed 1 100
4. Enter show qos to check the administered values.
5. Enter quit to exit.
!
Important:
Important: Ensure that the port settings on the Ethernet switches are set to the same values
as shown above in the set port commands.
Resetting the IPSI
The following steps resets the IPSI and ends the administration session.
1. Type reset and press Enter
Answer Y to the warning.
Note:
Note: Resetting the IPSI terminates the administration session. If further administration
is required, start a new telnet session to the IPSI.
Note:
Note: Control network settings (IP address, subnet mask, and gateway) become
effective when you exit the IPADMIN session.
2. Disconnect the laptop from the faceplate.
3. Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
Figure 6: LED display showing that the IPSI has a static IP address
)

Avaya S8100 Series Specifications

General

Brand	Avaya
Model	S8100 Series
Category	Server
Language	English