Issue 4.1 June 2005 39
Configuring Telnet for Windows 2000/XP
Note:
Note: Use a telnet session to access the information on the CD.
The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as 2 key presses. If running
Windows 2000/XP, you need to correct this before you copy the Remaster Program to the hard
drive.
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type display and press Enter to see the current settings. If message says
Sending only CR
then close the dialog box.
If message says
Sending both CR & LF
then continue with step 4.
4. Type unset crlf and press Enter.
5. Type display and press Enter to verify that the settings changed. The message says
Sending only CR
6. Close the dialog box.
To Next Page
Loading...
Need help?
General
