Issue 4.1 June 2005 15
Chapter 1: Introduction
These procedures are for installing Avaya Communication Manager and configuring a new
Avaya S8700 series media server and associated components in either a Multi-Connect or an
IP-Connect configuration. The installation procedures for both models are basically the same;
where they differ is noted.
As part of the procedures for configuring the various pieces of hardware, you use two
administration interfaces: the Maintenance Web Interface and a command line interface using
either telnet or a terminal emulation program such as Avaya Native Configuration Manager. You
also use the Avaya Installation Wizard to configure the media servers.
There are no requirements to install the media servers before the media gateways; however,
the license file only allows 30 minutes to "see" the administered and connected reference IP
Server Interface (IPSI) circuit pack located in the media gateway.
The following information is included in this installation procedure:
● Pre-installation information on page 16
- Equipment specifications on page 19
- Required hardware
on page 21
● Connecting the Ethernet ports on page 24
● Connecting the USB modems on page 25
● High level overview of installation process on page 27
● Configuring the hardware in the rack on page 29
- Configuring the SNMP modules in the UPS on page 30
- Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 34
- Configuring the media server on page 42
- Configuring the media server
on page 42
● Translating the IPSIs on page 51
● Connecting to the IPSIs on page 57
● Completing the installation administration on page 71
● Installing the media gateways on page 81
● Testing the media server installation on page 83
● Accessing the media server on page 95
● Troubleshooting an installation on page 105
To Next Page
Loading...
Need help?
General
