Telneting to media server
Issue 4.1 June 2005 79
Telneting to media server
Enabling alarms uses Linux commands through Telnet.
The following steps start a telnet session.
1. Click Start > Run to open the Run dialog box
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as craft or dadmin.
Enabling alarms
To INADS via modem
Note:
Note: These steps must be done on both media servers.
These steps enable alarms to INADS via the modem.
1. Type almenable -d b and press Enter
.
2. Type almenable and press Enter to verify that the alarms are enable
d.
To INADS via SNMP
Note:
Note: Do these steps only if a Secure Service Gateway (SSG) is being installed.
Note:
Note: These steps must be done on both media servers.
These steps enable alarms to INADS via SNMP.
1. Type almsnmpconf -d ipaddress -c communityname and press Enter, where
ipaddress is the trap receiver address for the SSG device and communityname is the
community string name required by the SSG device.
2. Type almsnmpconf and press Enter.
Verify that the correct information was entered.
3. At the prompt, type almenable -s y and press Enter.
To Next Page
Loading...
Need help?
General
