Avaya Vantage - Page 148

Audio parameters
Parameter Type Default
value
Is set to
default
on reset
Description
ENABLE_OPUS Numeric 1 Yes Specifies whether the OPUS codec is enabled.
Assign one of the following values:
• 0: Disabled.
• 1: Enabled WIDEBAND_20K.
• 2: Enabled NARROWBAND_16K.
• 3: Enabled NARRWOBAND_12K.
For provisioning, use the SET command in the
46xxsettings.txt file.
OPUS_PAYLOAD_
TYPE
Numeric 116 Yes Specifies the RTP payload type that is used for the
OPUS codec. The range is from 96 to 127.
This parameter is used when media offer is sent to
the far end in INVITE or 200 OK when INVITE
with no SDP is received.
For provisioning, use the SET command in the
46xxsettings.txt file.
Video parameters
Parameter
Type Default
value
Is set to
default
on reset
Description
VIDEO_MAX_BAN
DWIDTH_ANY_NE
TWORK
Numeric 1280 Yes Specifies the maximum bandwidth for video calls.
The bandwidth is measured in kilobits per second
(kbps).
You can assign one of the following values:
• 0: Video is blocked.
• 1 to 10000: Maximum allowed bandwidth.
For provisioning, use the SET command in the
46xxsettings.txt file.
ENABLE_VIDEO Numeric 1 Yes Specifies whether video is enabled or disabled.
You can assign one of the following values:
• 0: Video is disabled.
• 1: Video is enabled.
For provisioning, use the SET command in the
46xxsettings.txt file.
Supported configuration parameters
May 2018 Installing and Administering Avaya Vantage
™
148
Comments on this document? infodev@avaya.com