Avidyne Envision EX5000 - PFD Messages; Table 9.15 PFD Messages

Reference
Envision EX5000 -112- 600-00151-001 Rev 01
9.11 PFD Messages
Lightning Position
Source OK
(TWX-670 only)
The position reporting
source (GPS or FMS)
connected to the TWX-
670 has returned to
normal operation.
Acknowledge.
Noise Present
(TWX-670 only)
The TWX-670 has
detected excessive noise
in the system. Accuracy
and efficiency of the
lightning sensor may be
negatively affected.
Have configuration
check at an Avidyne
Authorized Entegra
Service Center.
Stuck MK
(TWX-670 only)
Microphone PTT switch is
stuck open. Lightning
strikes will not be
displayed until the
problem is fixed.
Check the aircraft PTT
switches. If the problem
persists, have the
aircraft checked at an
Avidyne Authorized
Entegra Service Center
No Position Data
(TWX-670 only)
The position reporting
source (GPS or FMS)
connected to the TWX-
670 is not sending
position data.
Cycle position sensor
power.
Have configuration
checked at an Avidyne
Authorized Entegra
Service Center.
Table 9.15 PFD Messages
PFD Messages &
Colors
Meaning Recommended Pilot
Action
PFD is Operating
Normally
PFD is operating in a
normal state from a
recoverable fault that
was previously
acknowledged.
Acknowledge.
PFD is Not
Communicating
MFD is receiving no
data from PFD
Have an Avidyne Entegra
Authorized Service Center
check configuration and
installation.
Table 9.14 Lightning Messages (Continued)
Lightning
Messages & Colors
Meaning Recommended Pilot
Action