Avidyne Envision EX5000 - Aux Main Page

Aux Page – Configuring the EX5000
Envision EX5000 -76- 600-00151-001 Rev 01
3) Time Zone—Set the time zone for your location, based on an
offset from UTC.
4) Menu Timeout—Set the amount of time that the menus remain
visible on Map page from the following choices (in seconds): 2, 5,
10, 20, 30, 40, 50, 60, Never.
5) Save—Saves settings and returns to the Aux Main page.
6) Cancel—Cancels any changes and returns to the Aux Main
page.
7) Change knob—The left knob changes the value or status of the
selected field.
8) Select knob—The right knob moves the blue field selector.
Note: The EX5000 maintains a constant offset from UTC and does not
adjust local time for daylight savings.
Note: If the EX5000 time has drifted noticeably from the current GPS time,
ensure the GPS unit(s) are receiving valid GPS information by re-synching
the EX5000 time as follows:
• Enter the System Time page.
• Change the “Time Source” setting from “Auto” to “GPS”
• Return the setting to “Auto” and press the “Save” button.
• If the “Time Source” was previously not set to “Auto”, change the setting
to “Auto” and press the “Save” button.