Data Block Edit Page
600-00151-001 Rev 01 -73- Envision EX5000
7.3 Data Block Edit Page
Data blocks in the upper corners of the Map page can be edited to
display information from a list of available data types. A series of
dashes represents data that is invalid or unavailable.
Figure 7.4 Data Block Edit Page
1) Factory Defaults—Resets the Data Blocks to the original display
mode.
2) Left & Right Data Blocks—The Upper Left and Upper Right
Data Blocks are user-configurable data blocks that appear in the
upper left and upper right of the Map pages. You can keep these
data blocks at the default factory configuration or you can
customize the data that appears in the data blocks. The factory
default uses the data blocks as follows:
n Upper left contains engine and fuel data
n Upper right contains navigation data.
Each data block can have as many as 6 lines of data. If you
configure BLANK lines, the data block is resized to show only
65
3
4
1
2
2
To Next Page
Loading...
