CMax Chart Pages (Optional)
Envision EX5000 -30- 600-00151-001 Rev 01
5) Select Chart—Displays the Selection page to allow you to select
a new chart for display. For more information, see Section
3.7, "CMax Selection Page" on page 39.
6) Display—Display allows you to toggle between displaying Airport
and Procedure charts.
n Display Airport shows when the current Procedure chart
displays. Press Display Airport to display the Airport chart.
n Display Procedure shows when the current Airport chart
displays. Press Display Procedure to display the Procedure
chart.
7) View—Controls which portion of the chart is being displayed. See
details below.
8) Remove Labels—Removes the button labels from the page to
allow a full view of the current chart. Press any button again to
redisplay the labels.
9) Ownship—Displays the current position of the aircraft. The chart
nominally remains fixed and the ownship symbol moves across
the chart with aircraft movement.
10) Pan Buttons—The right-hand buttons allow you to manually
move the chart on the screen. The pan buttons are only active
when the current view can be panned. The Plan view of each
chart can generally be panned; many information pages, such as
header and departure views, cannot.
Not shown: Center—When you use Pan, the Center button is
displayed to allow you to re-center the chart. When panning, the
aircraft position, and ownship symbol, may move towards or off
the edges of the chart area. Press Center to re-center the chart
on the current position hide the Center button.
11) Zoom Control knob—The right knob allows you to zoom the
chart for close-up examination of a specific area. The label only
appears when the current view can be zoomed. Most information
view pages, such as headers, cannot be zoomed. If you have
panned the chart, zooming all the way out to the full-screen chart
size also re-centers the chart on the screen.
A typical approach procedure chart is shown in Figure 3.3:
To Next Page
Loading...
