CMax Chart Pages (Optional)
Envision EX5000 -42- 600-00151-001 Rev 01
2) AutoFill—When pressed, moves the detected destination airport
listed on the button into the Airport Entry Field.
3) Select Chart—Moves the active selection cursor from the Airport
Entry Field to the Chart Selection list.
4) Next Letter—Use Next Letter to move the cursor within the
Airport Entry Field to the next character location.
5) Select knob—Use the right knob to select the character for the
current cursor position when entering an airport identifier. The
character selection scrolls through A to Z, 0 to 9, and common
punctuation marks and symbols before returning to A.
Note: The AutoFill button automatically detects the destination airport if the
final waypoint is an airport or a waypoint that is part of an instrument
approach procedure. However, for some approaches,
AutoFill may detect
another nearby airport rather than the intended destination
. Make sure the
desired airport is displayed before pressing the button.
AutoFill does not
display under the following conditions:
• An Airport cannot be determined due to GPS limitations.
• When the feature is not supported by some GPS models.
• The current airport destination is not available in your chart data
coverage area.
To Next Page
Loading...
