Nearest Page (NRST)
Envision EX5000 -64- 600-00151-001 Rev 01
n BRG—Bearing to the airport.
n NM—Distance to the airport.
n Freq—Radio frequency to contact this airport.
n Name—Airport common name.
2) METAR Conditions—Displays the decoded text METAR for the
selected airport when Broadcast Datalink is enabled and a
METAR is available.
3) Airport Info—Provides quick access to airport information for the
airport highlighted. Airport Info only appears when viewing the
Airports Nearest to Position and Airports Nearest to Destination.
Airport Info displays a page similar to Figure 6.2.
4) TYPE—Cycles through the various Nearest data types in the
following order:
n PPOS APT (Airports Nearest Present Position)—
Graphical METARs, airport identifier, bearing, distance from
the aircraft present position, frequency, and airport name.
n DEST APT (Airports Nearest Destination)—Graphical
METARs, airport identifier, bearing, distance from the aircraft
present position, frequency, and airport name.
n VORs—Identifier, bearing, distance, frequency, and name.
n NDBs—Identifier, bearing, distance, frequency, and name.
n Intersections—Identifier, bearing, and distance.
n Obstacles—MSL (and AGL) height, bearing, and distance.
5) FILTER—Press to see all airport types (SHOW ALL) or only the
airport types as defined on the Airport Filter page (ON) (see
Section Figure 7.2, "Airport Filter Setup Page" on page 69). Filter
is only visible on the Nearest Airport pages.
6) Chart—If CMax charts are installed and you select an airport that
has a chart icon, the Chart button appears, which provides a
quick jump to the selected approach charts. For information
about CMax, see Chapter 3 "CMax Chart Pages (Optional) .”
7) Select knob—Use the right knob to move the cursor up or down
to highlight a specific airport or other data type.
To Next Page
Loading...
