Avidyne Envision EX5000 - Airport Filter Setup Page

Aux Page – Configuring the EX5000
Envision EX5000 -68- 600-00151-001 Rev 01
1) EX5000 Version Information—Software part number, serial
number, and media part number are displayed here. Expiration
dates for on-board databases are also shown on this page.
2) Message List including sensor status—A record of the
messages displayed in the message bar. If more messages are
active than space allows, the right knob allows scrolling.
3) Datalink Setup—Provides configuration options for the Datalink
Messaging.
4) Lightning Strike Test—Initiates a self-test of the lightning
sensor, if installed.
5) Traffic Standby/Traffic Self-Test—If a SkyWatch traffic sensor
is installed:
n Traffic Standby switches the sensor back into standby mode
only while on the ground. To view traffic data while on the
ground press Traffic in Map page.
n Traffic Self-Test replaces Traffic Standby after the Traffic
sensor has entered Standby. Initiates a 30 second self test of
the SkyWatch traffic sensor only while on the ground.
6) Nav Src—If your aircraft is equipped with multiple GPS units,
switches between GPS1 and GPS2 to provide position
information and flight plan data to the moving map.
7) Setup Menus—Buttons to select specific setup functions
including Airport Filter, Declutter Settings, Data Block Editing,
and System Time.
Scroll knob—(Not shown) If there are more messages than fit on
the current page, Scroll allows you to scroll the message list to
see the remainder of the messages.