Avocent Cyclades ACS 5000 - IPDU Power Mgmt. - View Ipdus Info; Table 3.4: IPDU Power Mgmt. - View Ipdus Info Description

Chapter 3: Web Manager for Regular Users 23
6. To change the outlet name or the post on delay, click the Edit button. The Edit Outlet dialog
box appears.
a. To change the name assigned to the outlet, enter a new name in the Outlet Name field.
Names must begin with a letter. Valid characters are letters, numbers, dash (-) and
underscore (_).
b. To change the Post On Delay (the time between when this outlet is turned on and another
can be turned on), change the default 0.50 number of seconds in the Post On Delay field.
NOTE: If you change the outlet name here, make sure it is consistent with any name that may have been
configured under Ports - Physical Ports - Power Management.
7. Click OK.
8. Click the Save Outlets State button (saves outlet states to the IPDU only).
NOTE: For Avocent SPC power devices or Server Technology IPDUs, a dialog box prompts you that the screen
automatically reloads. Click OK and wait for confirmation that the page has been reloaded.
9. Click apply changes.
IPDU Power Mgmt. - View IPDUs Info
If you select IPDU Power Mgmt. - View IPDUs Info, you can view the following information about
each port configured for power management
.
Table 3.4: IPDU Power Mgmt. - View IPDUs Info Description
Screen Heading Description Example
ID Either a default name or administrator-configured IPDU
ID appears followed by the serial port number to which the
IPDU is connected in parentheses.
i1A (serial port 1)
Model The model of supported IPDU connected to the console
server at the designated port.
Cyclades PM8
Number of Outlets The number of outlets on the IPDU. 8
Number of Inlets Total number of inlets available on the target IPDU. 1
Syslog Whether syslogging has been configured for messages
from this IPDU.
ON when syslogging
is configured
Buzzer Whether a buzzer has been configured to sound when a
specified alarm threshold has reached.
ON when the buzzer
is configured
Software Version IPDU firmware version installed on the IPDU. 1.7.0
Polling Rate The time interval at which the IPDU is polled by the PMD. 10000 ms
Current [value] The instantaneous current measured from the IPDU at
this time.
1.3 A