41
CHAPTER
5
Web Manager Wizard Mode
Step 1: Network Settings
An administrator can select Step 1: Network Settings in Wizard mode to configure network settings.
Basic network settings that are required to enable logins through the Web Manager are configured
during initial setup. Skip this step if the current settings are correct.
NOTE: An administrator can use the Expert - Network - Host Settings screen to perform advanced network
configuration.
If DHCP is disabled, additional fields appear that allow the administrator to configure a static IP
address.
To configure the network settings:
1. Select Wizard - Step 1: Network Settings.
2. To enable DHCP, make sure the DHCP checkbox is selected and select Step 2: Port Profile.
3. To disable DHCP, click on the checkbox to deselect DHCP.
4. Enter the required network information.
5. Click apply changes to save the configuration to Flash..
Step 2: Port Profile
An administrator can select Step 2: Port Profile in Wizard mode to enable all serial ports and to
configure the protocol and connection parameters used to access all devices connected to all serial
ports. This screen should be used to configure ports only if all serial ports are connected to the
consoles of target devices and only if all target devices have the same connection parameters.
NOTE: All serial ports are disabled by default and they cannot be accessed until an administrator enables them.
NOTE: An administrator can use the Expert - Ports - Physical Ports tabs to assign different parameters to
individual serial ports or groups of serial ports; specify Connection Protocols for other device types that may be
connected, such as terminals, modems, and IPDUs; authorize users and groups for access to individual ports;
configure data buffering and perform other advanced port configuration.
To Next Page
Loading...
