Chapter 5: Web Manager Wizard Mode 45
c. Select an option from the Show Menu pull-down menu. The choices are: show all options,
No, Show data buffering file only and Show without the erase options.
6. Click apply changes.
Step 5: System Log
An administrator can select Step 5: System Log in Wizard mode to configure one or more syslog
servers to receive syslog messages generated by the serial ports and by IPDUs, if IPDU power
management is configured.
NOTE: To configure a syslog server to store buffered data, select Expert - Ports - Physical Ports - Modify
Selected Ports - Data Buffering.
Make sure a configured syslog server is available on the same network as the console server. From
the syslog server administrator, obtain the the IP address of the syslog server and the facility
number for messages from the console server.
To add a syslog server:
This procedure assumes you have the IP address of the syslog server and the facility number for
messages coming from the console server.
1. Select Wizard - Step 5: System Log. The System Log screen appears.
2. From the Facility Number pull-down menu, select the facility number.
3. In the New Syslog Server field, enter the IP address of a syslog server and then click Add.
(Repeat this step until all syslog servers are listed.)
4. The new server(s) appears in the Syslog Servers list.
5. Click apply changes.
To Next Page
Loading...
