Chapter 7: Web Manager Network Menu Options 51
When an administrator selects the Add and Edit buttons under SNMPv3 Configuration, the New/
Mod SNMP v3 Configuration dialog box appears.
Figure 7.3: Expert - Network - SNMP - New/Mod SNMP v3 Configuration Dialog Box
To configure SNMP [Expert]:
1. Select Expert - Network - SNMP. The SNMP screen appears.
2. To enable any version of SNMP, perform the following:
a. To add an SNMPv1/SNMPv2 entry, click Add button the SNMPv1/SNMPv2
Configuration table.
b. To add an SNMPv3 entry, click Add at the bottom of the SNMPv3 Configuration table.
The New/Modify SNMP Daemon Configuration dialog box appears.
3. To edit any SNMP configuration, perform the following steps.
a. For SNMPv1 or SNMPv2 select the entry from the SNMPv1/SNMPv2 configuration list
and click Edit.
b. To edit an SNMPv3 entry, select an entry from the SNMPv3 Configuration list and click
Edit. The New/Modify SNMP Daemon Configuration dialog box appears.
4. For SNMP v1 or v2 configuration, enter or change the following information:
a. Enter the community name in the Community field.
b. Enter the source IP address or range of IP addresses in the Source field.
5. For SNMP v3 configuration, enter or change the following information:
a. Enter the username in the User name field.
b. Enter the password in the Password field.
NOTE: The SNMPv3 password must be fewer than 31 characters.
6. For any version of SNMP, perform the following:
a. Enter the unique object identifier for the object in the OID field.
b. Select Read Only or Read/Write from the Permission menu.
To Next Page
Loading...
