Bailey Infi 90 - Page 11

I-E96-506B1 v
Table of Contents
(continued)
Page
APPENDIX B - MODULE POWER REQUIREMENTS ...............................................................B-1
INTRODUCTION.......................................................................................................... B-1
CALCULATING CURRENT REQUIREMENTS................................................................ B-1
SIZING THE MODULAR POWER SYSTEM.................................................................... B-5
Sizing Systems with IEPAS02 Modules Only .......................................................... B-5
System Calculation Example Using IEPAS02 Modules Only................................... B-6
For Systems Using Both IEPAS02 and IEPAF02 Modules ...................................... B-7
System Calculation Example Using IEPAS02 and IEPAF02 Modules ...................... B-9
MAXIMUM POWER ENTRY PANEL CURRENT DRAW................................................. B-10
APPENDIX C - WIRING DIAGRAMS..........................................................................................C-1
INTRODUCTION.......................................................................................................... C-1
APPENDIX D - RETROFITTING THE MODULAR POWER SYSTEM.......................................D-1
INTRODUCTION.......................................................................................................... D-1
NETWORK 90 POWER SYSTEM REMOVAL ................................................................. D-2
Required Tools ...................................................................................................... D-2
Power Entry Panel Removal................................................................................... D-2
I/O Power Panel Removal...................................................................................... D-3
Module Power Panel Removal ................................................................................ D-3
Fan Assembly Removal ......................................................................................... D-4
Installing the INFI 90 Power System ...................................................................... D-4
Wiring the INFI 90 Power System .......................................................................... D-5
APPENDIX E - IEPAS01/IEPAF01 POWER MODULE REPLACEMENT.................................. E-1
INTRODUCTION.......................................................................................................... E-1
REPLACING POWER MODULES.................................................................................. E-1
POWER SYSTEM SIZING............................................................................................. E-1
LOAD SHARING .......................................................................................................... E-1
SYSTEM EFFECTS ON MODULE LEDS ....................................................................... E-2
List of Figures
No. Title Page
2-1. Modular Power System Architecture .......................................................................2-1
2-2. Power Distribution to the IEPAS02 System Power Module ......................................2-5
2-3. IEPAS02 Module Converter and Status Circuitry ....................................................2-6
2-4. Status Signal Block Diagram..................................................................................2-7
3-1. Circuit Breakers CB1/CB2 ....................................................................................3-3
3-2. AC Transfer Module, Switch S1 ..............................................................................3-5
3-3. IEPEP03 Power Entry Panel, Rear View ..................................................................3-6
3-4. Bus Monitor Module, Switch S1 and Jumpers J1 through J8 .................................3-7
3-5. Recommended Power Module Layout for Module Mounting Unit ...........................3-10
3-6. IEPAF02 and IEPAS02 Power Module Board Layout .............................................3-11
3-7. Rear of IEPEP01 and IEPEP02 Power Entry Panels ...............................................3-13
3-8. Heat Shrink Tubing for 5 VDC Connection ...........................................................3-15
3-9. Heat Shrink Tubing for 24 VDC Connection .........................................................3-16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com