Basler BE1-11g - Page 664

652 9424200994 Rev N
Table 261. Application Firmware Revision History
Firmware
Version and Date
Change
1.01.00, Apr-09
• Initial release
1.02.00, Aug-09
• Made internal improvements invisible to the user
1.03.00, Nov-09
• Improved COMTRADE report
• Improved calculation of power values
• Improved access timeout length
• Improved sequence of events downloading/viewing
• Improved communications to prevent lockups
• Improved RAM write access during BE1-11g startup
• Improved operation of hold attribute on contact outputs
• Improved three-wire power metering
1.03.01, May-10
• Improved low-voltage metering
• Improved 81R (rate of change of frequency) function
• Improved resolution of values on COMTRADE report
2.04.00, Aug-10
• Implemented IEC 61850 protocol option
• Under Settings Explorer, moved Display Units from System
Parameters to General Settings
2.04.01, Mar-11
• Implemented Secure Access Login for Modbus
• Implemented Alarm Resetting function for Modbus
2.04.02, Jun-11
• Improved IEC 61850 communications
2.05.00, Oct-11
• Added Output Override Alarms
• Enhanced voltage settings resolution for 27, 59, and 81
elements
2.05.01, Jun-12
• Improved target reporting
• Corrected issue where bad data in log file could prevent correct
power-up of relay
2.06.00, Sep-12
• Added support for RTD module (49RTD protection and analog
input protection elements)
• Added 78V Vector Jump protection, 21 Distance protection, 25A
Synchronizer, 87 Phase Differential protection, 87 Neutral
Differential protection, and 78OOS Out of Step protection
• Added unbalance current protection mode for the 50 and 51
elements
• Added support for enhanced front panel in J type case
•
Added security logging
2.06.01, Nov-12
• Added Delta/Wye Compensation Enable setting for the Distance
(21) element
2.06.02, Dec-12
• Improved 87N operation
• Improved logic timers
• Improved SEF pickups
• Improved output override operation through the front panel
2.06.03, Mar-13
• Improved 51, 25, and 25A element operation
• Improved port access timers
• Improved angle compensation in differential report
•
Added DNP data
2.06.04, Mar-13
• Improved 21 element operation
•
Improved distance to fault measurement
Revision History BE1-11g