Safety
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10
17
of 314
2
2.5 Responsibility of the operating company
The device will be used in commercial areas. Thus, the proprietor of the device is subject
to the legal work safety regulations.
Along with the notes on work safety in these instruction handbook, the safety, accident
prevention and environmental protection regulations valid for the area of application of
this device must be complied with. Whereby:
m Th
e operating company must inform himself about the applicable work health and safe-
ty regulations and ascertain, in a hazard ass
essment, any additional hazards that could
arise from the special working conditions in the use area of the device. These must
then be implemented in the form of instruction handbook for operation of the device.
m Th
ese instruction handbook must be kept accessible to personnel working with the de-
vice at all times in the immediate vicinity of the device.
m Th
e specifications of the instruction handbook must be adhered to completely and
without exception.
m Th
e device may only be operated in a technically faultless and operationally safe con-
dition.
2.6 Protection devices
Protection classification
BM5X1X, BM5X2X IP 20
BM5X3X, BM5X4X IP 20, with a contact-isolated con-
nection in accordance with IP 20,
ot
herwise IP 10.
BM5X5X, BM5X6X, BM5X7X IP 00
All devices BM5
500, BM5600, BM5700 must be installed in an appropriate control cab-
inet to meet the protection classification required in EN 61800-5-1, chapter 4.2.3.3 (IP 30:
only upper horizontal surfaces; IP 20: all other surfaces).
DANGER!
Risk of fatal injury from electrical current!
There is an immediate risk of fatal injury if live electrical parts are contacted.
Therefore:
m The device must be in operated inside of a control cabinet that provides protection
against direct contact of the devices and at least meets the requirements of
EN 61800-5-1, chapter 4.2.3.3.
To Next Page
Loading...