Baumuller b maXX 5500 - Connection of Several Devices to the DC Link Without Using the Signal Bus

Installation
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10
177
of 314
7
7.11.1.3 Connection of several devices to the DC link without using the signal bus
There are the following possibilities to connect devices.
Via X300 
signal bus
Signal bus X300
Do not connect power supply bus X100:3 and brake resistor bus X100:4!
Figure 86: Connection of several devices BM5500 via signal bus
Via X100 
power supply bus/
bra
ke resistor bus
Brake resistor bus X100:4
Power supply bus X100:3
Power supply bus
Brake resistor bus
Power supply bus
Brake resistor bus
Power supply bus
Brake resistor bus
Do not connect signal bus!
Figure 87: Connection of several devices BM5500 without signal bus
NOTICE!
It is forbidden to connect both the signal bus X300 and the power supply bus/brake
resistor bus X100:3/X100:4. This leads to damage of the devices!