Installation
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10
179
of 314
7
7.11.2 Terminal overviews
ZFigure 92– on page 183 and the following show the connections for protective conduc-
tors, power supply, motor, brake resistor, DC-link and motor temperature sensor (X101).
ZConnections controller– from page 193 shows the control voltage and the connections
of the controller unit.
NOTE!
The use of the ballast switch is not possible in combination with a disabled safety re-
lay of a BM551X or BM552X.
NOTE!
The characterization 1C1 and 1D1 is from the standard DIN EN 60445.
1C1 is the connection to the positive DC link cable/current bar and was labeled with
ZK+ by Baumüller in the past.
1D1 is the connection to the negative DC link cable/current bar and was labeled with
ZK- by Baumüller in the past.
To Next Page
Loading...