Monitoring
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10 Baumüller Nürnberg GmbH
222
of 314
8.3
8.3 Monitoring
The controller unit monitors the device during operation. If the controller unit detects a
state that deviates from the normal operation condition, the device either transmits a
warning or an error message.
Warning If the controller unit detects an operating condition that exceeds a warning threshold, a
corresponding warning is shown on the display or, respectively, controller. The most im-
portant warning message (Current limit attained) is also shown by the device through the
LED H13 or H23 (refer to ZDisplay and operation elements– from page 128).
Error message If the controller unit detects that the device is not working error-free, then this is shown
via the LED H14 or H24 (refer to ZDisplay and operation elements– from page 128). A
corresponding error code will continue to be shown on the display and/or a controller can
read out the error code on the device.
For further information refer to ZTroubleshooting and fault correction– from page 237.
To Next Page
Loading...