Requirements to the executing personnel
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10 Baumüller Nürnberg GmbH
298
of 314
12.2
12.2 Requirements to the executing personnel
The personnel, who is appointed to setting out of operation, must have the required
knowledge and instructions, which is necessary for an execution according to the rules.
Select the personnel in such a way, that the safety instructions, which are mounted to the
device and its parts as well as to the connections, are understood and applied to.
12.3 Shutdown
Execute the setting out of operation as follows:
1 p
ut the device off-circuit and assure the device against unintentional restart.
2 ch
eck the isolation from supply of all connections (earliest 10 minutes after switching
off).
3 de
mount the connections and protect the connections according to the safety instruc-
tions.
4 d
ocument the shut down setting.
12.4 Demounting
The demounting assumes a completed, documented setting out of operation.
1 sec
ure the device against falling off/out.
2 l
oosen all mechanical connections.
3 l
ift the device out of the control cabinet.
4 stor
e the device in a suitable packing.
5 a
t transportation pay attention to, that the device is not damaged by wrong storage or
severe shocks, also refer to ZWh
at to observe when transporting– on page 139 .
NOTICE!
Not
e sharp edges.
In case, while installing, you lift a device with unprotected hands, fingers/palm can be
cut. If the device falls off, your feet can be cut up.
Therefore:
Therefore:
m Ens
ure that only qualified personnel, who are familiar with the safety notes and as-
sembly instructions, demount
this device.
Wear safety gloves.
mWear safety
shoes.
To Next Page
Loading...