Installation
Instruction handbook b maXX BM4400, BM4600, BM4700
Document No.: 5.12008.07
195
of 358
7
7.11 Controller terminals
NOTE!
This Instruction Handbook describes the controller without function and option mod-
ules. A corresponding manual is available to each function/option module, refer to
ZList of other applicable documents– on page 13.
HINWEIS!
1)
If you consider UL508C, limit the current to 4 A.
2)
Do not apply voltage to the terminals X100-3 or X100-4, if the device is not supplied
via X100-1/2 with voltage.
The signals „mains on“ and „brake resistor“ are internal digital control signals of the
system b maXX 4000. They are used at applications with DC link connection.
3)
)
The PSI-module may not be attached or withdrawn, if the b maXX 4000 24 V pow-
er supply is ON. Beforehand switch off the device.
Further notes for the usage of the PSI module are to be found in parameter manual.
4)
not BM44XX - XXX - XX0XX and BM44XX - XXX - XX1XX
To Next Page
Loading...
