Baumuller BM4400 - Error Messages (2 Nd Level)

Troubleshooting and fault correction
Instruction handbook b maXX BM4400, BM4600, BM4700
Document No.: 5.12008.07
241
of 358
9
1st level 1st level errors are only interesting for the access to errors via parameters, to be used
without ProDrive, e. g. at Field bus communication. This errors are not shown in ProDrive/
7-segment display.
Bit mapping see description of the parameter P0200 in the parameter manual.
2nd level
3rd level
Order of the error messages see survey (ZFigure 103– on page 240).
2nd level error messages are displayed on the 7-segment display in ProDrive.
9.4.2.1 Error messages (2nd level)
In the column „Reaction“ the reaction of the system to the error is shown:
m „IS“ = pulse inhibit;
m „adjustable“ = the error reaction can be set via ProDrive (Window „Drive management“,
toolbar button „Error reaction“).
m „no reaction“ means, the drive is continuing to work and the red error LED is blinking.
P0201 Error processor
NOTE!
3rd level errors are only displayed in ProDrive separated by a decimal point from the
corresponding 2nd level error.
e.g.:
Motor error 102: Group error find notch position (2nd level)

Find notch position error 102.64: Drive moved more than 4 times delta angle.
(3rd level)
Error No. Meaning Reaction Troubleshooting
0reserved
1 Watchdog error IS Restart b maXX 4000
2 Incorrect or unexpected interrupt has occurred IS
3 NMI Interrupt / bus error IS
4 to 15 reserved, not assigned = 0