Baumuller BM4400 - Encoder Connection Slot;Position a and B

Installation
Instruction handbook b maXX BM4400, BM4600, BM4700
Document No.: 5.12008.07
203
of 358
7
7.11.1 Encoder connection slot/position A and B
m BM4-F-ENC- 01, BM4-F-ENC-11, BM4-F-ENC-21; Resolver plug-in module
Some encoders are listed in ZEncoder modules slot/position A and B– on page 123, pre-
assembled encoder cables see ZEncoder cables– from page 307. 
All encoders, which comply to the following technical specifications, may also be used:
NOTE
For further information see Instruction Handbook Encoder modules 5.01042.
Number of pole pairs The ratio between the number of motor pole pairs and
of the number of pole pairs of the encoder must be
integer.
1)
Permitted current input max. 160 mA
Excitation frequency 4 kHz
Excitation current 160 mA
Transmission ratio BM4-F-ENC-01 0.5
BM4-F-ENC-11 0.28
NOTE
Resolvers are to be used only for motors with maximum ten pole pairs.