baxter Auto Syringe AS50 User Manual

07-19-B3-430 Auto Syringe AS50 Infusion Pump Operator’s Manual Page 75
Display, Battery, and Syringe Sensor Check
1. Be sure that no syringe is mounted, and
that the barrel clamp is closed.
2. Press and hold the STOP key during the
normal power-up Lamp Test. Compare
the display to the illustration. Verify that
all annunciators, decimal points and
digits are legible.
3. Be sure that all lights on the Status
Panel light up during the Lamp Test.
Note: If the charger is plugged in, the
ON
CHARGE
light will be on before, during and
after the lamp test.
4. Release the STOP key.
Note: If
CHECK BARREL, CHECK FLANGE or
CHECK PLUNGER is displayed, one of the
syringe mounting sensors may be malfunc-
tioning. Make sure the plunger rod, flange
and barrel capture mechanisms are free.
Turn the pump off and back on again. If the
error message is repeated, remove the
pump from service.
Keypad Check
1. After the pump completes the power-up Lamp Test, press every key except ▲, ▼, and
CONFIRM in any order, one key at a time. Each keypress should result in a short
beep.
2. Press any two (or more) keys simultaneously. There should be no response.
3. Press and hold any key (except ▲, ▼, START, STOP, and CONFIRM). There should be
only one beep, no matter how long the key is held down.
4. Press and hold any key (except ▲, ▼, START, STOP, and CONFIRM), then press any
other key. There should be no response to the second keypress.
5. Press and briefly hold down START and STOP, one at a time. The pump should sound
repeated beeps while each key is held down. Holding down
START for a prolonged
period of time will cause a failsafe alarm.
O
VER
B
OD
Y
WT
hr
:min
k
g
NEXT
D
OSE
IN
hr
:min
k
g
U
m
g
h
r
S
YRIN
GE
mfr
s
i
z
e
EVER
Y
CO
N
C
.
U
nit
s
hr
:min
L
m
g
m
INF
USE
RA
TE
A
A
L
m
L
m
min
hr
T
O
T
AL DR
T
T
UG
V
OL
T
O
T
AL FINAL
T
T
m
gr
a
m
s
mLmc
g
V
O
L LIMIT
V
OL
L
m

baxter Auto Syringe AS50 Specifications

General

Brand	baxter
Model	Auto Syringe AS50
Category	Water Pump
Language	English