07-19-B3-430 Auto Syringe AS50 Infusion Pump Operator’s Manual Page 3
Device DescriptionChap ter 2
The Auto Syringe AS50 Infusion Pump (hereinafter referred to as “the pump”) is designed
to meet the fluid and drug delivery requirements of today’s changing clinical environment.
It provides accurate, continuous or intermittent infusion of intravenous solutions, drug
solutions, whole blood, and packed red blood cells.
The pump is indicated for infusion via intravenous (IV), intra-arterial (IA), epidural, or
subcutaneous routes of administration. It can be piggybacked into an ongoing infusion
line to deliver secondary solutions automatically, precisely, and economically. Infusion
rates are programmable from 0.01 to 438 mL/hr.
The pump accepts standard disposable syringes from 1 mL to 60 mL in size. A numeric
keypad simplifies programming and makes the pump easy to use. During programming,
the status display prompts the user to enter data about the syringe and the infusion.
While the pump is running, the status display shows information about the infusion.
Safety and effectiveness are reinforced by pre-programmable bolus operation, titration of
a dose without interruption of fluid flow, and easily understood alarm and alert messages.
The pump includes an optional serial communication feature, which provides remote
computer control and monitoring capabilities. A standard 9-pin connector allows an
RS-232 communication link between the pump and the host computer. The “Auto Syringe
AS50 Infusion Pump Programmer’s Manual” describes the use of this feature.
The pump can be custom-configured to select key features that meet specific
requirements. Configurable options include:
● Audio range
● Auto default to previous mode
● Backlight
● Infusion mode selections
● Keypad auto lock
● Maximum infusion rates
● Occlusion pressure sensitivity
● Protocol library
● Remote computer control
● Syringe manufacturer, type and size selections
To Next Page
Loading...
Need help?
General
