baxter Auto Syringe AS50 User Manual

Detailed Instructions
Page 30 Auto Syringe AS50 Infusion Pump Operator’s Manual 07-19-B3-430
6. Grasp the FINGER GRIP (1) on the DRIVER (2) and pull it all the way out. Slide the
DRIVER down until it contacts the syringe plunger, then release.
7. Push the PLUNGER CLAMP in firmly to capture the syringe plunger.
Turn the Pump On and Off
The ON/OFF switch is on the left side of the pump, near the bottom. Turn the pump on by
sliding the switch up to the
ON position.
Note: If the syringe is improperly mounted, the pump displays one of the following alert
messages:
CHECK BARREL, CHECK FLANGE, or CHECK PLUNGER. Examine the
syringe and correct the indicated problem. If a combination of conditions is
sensed, the pump displays a
CHECK SYRINGE alert or alarm message instead.
The pump is turned off by sliding the switch down to the
OFF position.
1
2
O
N
/OF
F
S
WIT
C
H

baxter Auto Syringe AS50 Specifications

General

Brand	baxter
Model	Auto Syringe AS50
Category	Water Pump
Language	English