Circlip and Cotter Pin
Replace the removed circlip or cotter pin with a new one. In
order to prevent deformation, the opening of circlip or cotter pin
cannot be too large during installation.
Lubrication
In order to minimize the abrasion during running-in, the
lubricant must be applied to the rotating parts or sliding parts. The
appropriate amount of lubricant or grease shall be injected in
accordance with the specifications, and this Manual will give the
various lubrication points.
Rotation Direction of Engine
When the crankshaft is rotated by hands, the wrong free play
amount adjustment will be caused if the rotation direction is wrong.
So please rotate the crankshaft in the positive direction (clockwise
direction from the output).
1-7
To Next Page
