●After the connection between two ends of throttle cable steel cable,
the steel cable shall be able to move freely [A].
★If the steel cable cannot move smoothly after the lubricant is
applied, the cable has been worn [B] or the throttle cable jacket is
broken [C], the throttle cable must be replaced.
Check Tightness of Bolt, Nut and Fastener
●Check the tightness of the bolts and nuts listed below. In addition, check whether all the cotter pins are in place and in
good condition.
Remark
○The tightness of engine fasteners shall be checked when the engine
is cooled (indoor temperature).
★If the fasteners are loose, tighten them according to the specified tightening order and tightening torque. For the
specifications on torque, see the corresponding chapters. Refer to the “Standard Torque Table” if the tightening torque is not
described in the relevant chapters. When any fastener is tightened, tighten it for 1/2 circle and then continue to tighten it.
★If the cotter pin is broken, it must be replaced with a new one.
2-49
To Next Page
Loading...
