Benelli TNT 25 User Manual

Replacing Spark Plug
●Remove the ignition coil (see “Disassembling Ignition Coil” in the
“Electrical System” chapter).
●Remove the spark plug [A] vertically with the wrench for spark
plug.
●Replace a new spark plug.
Standard Spark Plug
Model: NGK CR8E
●Insert a new spark plug into the spark plug hole and press the spark
plug tightly with your finger.
●Use the wrench [A] for spark plug to tighten the spark plug
vertically.
Note
If the wrench is tilted when the spark plug is tightened, the
insulator of spark plug may be broken.
Locking torque of spark plug: 13 N·m
●Fix the ignition coil firmly.
○Make sure that the fixed ignition coil is not easy to loosen.
2-71

Benelli TNT 25 Specifications

General

Displacement	249 cc
Bore x Stroke	72 mm x 61.2 mm
Compression Ratio	11.2:1
Max Torque	21.61 Nm @ 8000 rpm
Transmission	6-speed
Starting System	Electric
Clutch	Wet multi-plate
ABS	No
Front Tire	110/70-17
Rear Tire	150/60-17
Length x Width x Height	2080 mm x 810 mm x 1125 mm
Seat Height	780 mm
Kerb Weight	159 kg
Fuel System	Fuel Injection
Ignition	Digital
Front Suspension	Telescopic forks
Rear Suspension	Mono-shock
Front Brake	Disc
Rear Brake	Disc
Engine Type	Single cylinder, 4-stroke, liquid-cooled, DOHC