Crankshaft Sensor
Crankshaft Position Sensor Disassembly
●Integrated with the magneto, it cannot be disassembled separately
●Use the tester
*Note
The trigger can be checked on the engine.
Checking
● Disconnect the trigger lead coupler.
●Measure the resistance of red and yellow engine leads.
Standard value: 150±20Ω (20
)
★If the measured resistance value is higher than the specified value,
the coil circuit is disconnected and needs to be replaced.
★If the resistance value is lower than the specified value, the coil is
short-circuited and must be replaced.
7-16
To Next Page
