Benelli TNT 25 - Checking Brake; Checking Brake Fluid Level

★If the measured value does not meet the specified valve, the
adjustment shall be carried out.
○Adjust the free play of brake pedal.
1. Loosen the nut A above the connecting rod C.
2. Screw up or screw off the brake push rod B to adjust the free play
of brake pedal.
If the brake push rod B is tightened, the free play will be
reduced;
If the brake push rod B is unscrewed, the free play will be
increased.
3. When the free play meets the specified value, tighten and fasten
the nut A.
4. After adjustment, the brake dragging phenomenon shall not occur.
Checking Brake
●Ride the motorcycle on the dry road and check whether the front
and rear brakes are normal.
★If the brake is abnormal, check the brake system.
Warning
If you need to test the motorcycle in the checking process, make
sure to ride it in the place with safe traffic conditions.
Checking Brake Fluid Level
●Check whether the level of front brake fluid and brake fluid in the
reservoir [B] exceeds the lower limit oil lens [A].
Remark
○When checking the brake fluid level, rotate the handle to keep
the front brake reservoir horizontal.
★If the level is lower than the lower limit, add the brake fluid in the
front brake reservoir until the level reaches the high fluid level line
[A].
Remark
○Brake fluid can damage the painted surfaces or plastic parts.
Therefore, wrap the absorbent paper around the pump and clear the
spilled brake fluid immediately.
●Check the brake fluid cylinder diaphragm on the cover. If there is
any damage/wear, please replace the brake fluid cylinder diaphragm
2-34