Side Stand
Disassembling Side Stand
●Lift the rear wheel above the ground by using the bike stand.
●Removing:
Side stand spring [D],
Nut [B],
Side stand bolt [A],
Side stand [C],
Installing Side Stand
●Apply the grease to the moving part of side stand [C].
●Apply the Loctite to the thread of side stand bolt [A].
●Tighten the bolt and lock it with the nut [B].
Locking torque:
Side stand bolt [A]: 50 N·m
Side stand bolt locknut [B]: 45 N·m
●Install the spring [D] with longer end to face up.
6-113
To Next Page
