Replacing Rear Brake Fluid Pipe
Note
The brake fluid will quickly corrode the surfaces of painted parts,
therefore, if the brake fluid splashes on any plastic part, it must be
thoroughly rinsed immediately.
●Remove the rear brake fluid pipe clamp [A].
●When the rear brake fluid pipe is removed, do not splash the brake
fluid on any painted parts.
●When the rear brake fluid pipe [B] is removed, temporarily fix the
end of brake hose to a higher position to minimize the loss of brake
fluid.
●If the brake fluid spills, clear it immediately.
●The clamp needs to be replaced with a new one when the rear brake fluid pipe is installed.
●When the brake hose is installed, avoid significant bending, kinking, extrusion or twisting and arrange it according to the
section in the “Appendix” chapter: “Winding Method of Cable, Wire and Hose”.
●Fill the rear brake fluid pipe with brake fluid after the rear brake fluid pipe is installed. (See “Replacing Brake Fluid”).
2-61
To Next Page
Loading...
