Checking Idle Speed
• Start the engine and make it hot thoroughly.
• When the engine is idling, rotate the handlebar to both sides [A].
★If the idle speed was changed when rotating the handlebar, it
indicates that the throttle cable is not adjusted well or the winding
method is incorrect or damaged. Before riding, make sure to correct
the above problems (see the sections of “Accessory” chapter:
“Checking Throttle Control System” and “Winding Method of Cable,
Wire and Hose”).
Warning
If you ride when the cables are not adjusted well or damaged or
the winding method is incorrect, the safety accident will be
caused.
• Checking Idle Speed
Idle Speed
Standard: 1400±100 r/min
Checking Fuel Hose (Fuel Leakage, Hose Break and Hose
Installation Situations)
〇If the motorcycle is not handled properly, the high pressure inside
the fuel hose can lead to fuel leakage [A] or fuel hose break.
Remove the fuel tank (see “Fuel Tank Disassembly” in the “Fuel
Injection System (EFI)” chapter) and check the fuel hose.
★If any wear, crack [B] or expansion [C] is found, the fuel hose
must be replaced.
• Check whether the winding method of hose meets the relevant
specifications of the “Winding Method of Cable, Wire and Hose”
section of the “Accessory” chapter.
★If the hose is bent or broken seriously, it needs to be replaced.
Hose joint [A]
Fuel hose [B]
2-14
To Next Page
