Benelli TNT 25 User Manual

Strictly Prohibiting the Modification of Noise Control System
Fe
deral law prohibit anyone from doing or instigating others to do the following: (1) Any person removes any part or
make it inoperative before the final buyer purchases or receives any new motorcycle or in the course of the use of
motorcycle, unless there is a need to repair, maintain or replace this part; (2) any person continues to use the motorcycle
after removing any part of any motorcycle or making it inoperative.
The following acts belong to “modification of motorcycle”:
 Replace the original exhaust system or muffler with parts that do not comply with federal regulations.
 Remove muffler or any of its internal components.
 Remove air filter or its cover.
 Modify muffler or inlet system by means of cutting, drilling or otherwise, to increase noise level.
5

Benelli TNT 25 Specifications

General

Displacement	249 cc
Bore x Stroke	72 mm x 61.2 mm
Compression Ratio	11.2:1
Max Torque	21.61 Nm @ 8000 rpm
Transmission	6-speed
Starting System	Electric
Clutch	Wet multi-plate
ABS	No
Front Tire	110/70-17
Rear Tire	150/60-17
Length x Width x Height	2080 mm x 810 mm x 1125 mm
Seat Height	780 mm
Kerb Weight	159 kg
Fuel System	Fuel Injection
Ignition	Digital
Front Suspension	Telescopic forks
Rear Suspension	Mono-shock
Front Brake	Disc
Rear Brake	Disc
Engine Type	Single cylinder, 4-stroke, liquid-cooled, DOHC