• Check the carbon canister according to the following steps.
〇Remove the battery bracket A.
〇Remove the carbon canister [C] and the hose [1] used to connect
carbon canister.
〇Check whether there are cracks or other damages on the carbon
canister.
★If any, it shall be replaced with a new one.
If the carbon canister
is used under normal situations, it can be
used normally within the service life of the motorcycle without
maintenance.
• Check the hose of fuel evaporation and recovery system according to the following steps.
〇Check whether the hose is connected firmly and whether the clamps are in place.
〇Replace the broken, corrosive or damaged hoses.
〇Install the negative pressure hose according to the “Winding Method of Cable, Wire and Hose” section in the “Accessory”
chapter.
〇When the hose is installed, avoid bending, tangling or twisting the hose excessively and do not bend the hose as much as
possible so as to prevent the blocking caused by evaporative emission.
2-16
To Next Page
