●Left/right turning indicator (LED) [B] in the meter panel will flash.
★If the left turn signal or right turn signal is not on, check or
replace the following parts:
Turn signal (LED) (see “Replacing Turn Signal” in the “Electrical
System” chapter);
Header parts of turning indicator (LED) (see “Checking Header
Parts” in the “Electrical System” chapter);
Turn signal switch (see “Checking Switch” in the “Electrical System”
chapter);
Wire harness (see “Checking Circuit” in the “Electrical System”
chapter).
●Push the turn signal switch back.
●The turn signal and turning indicator (LED) shall be off.
★If the lamps do not off, check or replace the following parts:
Turn signal switch (see “Checking Switch” in the “Electrical System”
chapter);
Step 3
●Turn the dimmer switch [A] to the position of low beam [A].
●Start the engine.
●Low beam head lamp [B] shall be on.
★If the low beam head lamp is not on, check or replace the
following parts:
Head lamp low beam bulb (see “Replacing Head Lamp Bulb” in the
“Electrical System” chapter);
15A fuse of head lamp (low beam) (see “Checking Fuse” in the
“Electrical System” chapter);
10A fuse of head lamp relay (see “Checking Fuse” in the “Electrical
System” chapter);
Head lamp circuit relay in the relay box (see “Checking Relay
Circuit” in the “Electrical System” chapter);
Head lamp relay (low beam) (see “Checking Head Lamp Relay” in
the “Electrical System” chapter);
Wire harness (see “Checking Circuit” in the “Electrical System”
chapter).
2-43
To Next Page
