5
12.37 Set/Read software OPP value. (86H/87H) 53
12.38 Set/Read software OPP delay time. (88H/89H) 54
12.39 Set/Read the rst measured point. (8AH/8BH) 54
12.40 Set/Read the second measured point. (8CH/8DH) 54
12.41 Set/Read Vd value in CR-LED mode. (8EH/8FH) 54
12.42 Clear protection state. (90H) 55
12.43 Enable/Disable voltage autorange function. (91H/92H) 55
12.44 Enabel/Disable CR-LED function. (93H/94H) 55
12.45 Send a trigger signal. (9DH) 55
12.46 Read the information of load (on-load capacitance, on-load time…). (A0H) 56
12.47 Read the information of E-load (max/min input voltage/current). (A1H) 56
12.48 Read the max measured voltage in list mode. (A2H) 56
12.49 Read the min measured voltage in list mode. (A3H) 56
12.50 Read the max measured current in list mode. (A4H) 57
12.51 Read the min measured current in list mode. (A5H) 57
12.52 Read on-load capacitance. (A6H) 57
12.53 Set/Read current rising slope. (B0H/B1H) 57
12.54 Set/Read current falling slope. (B2H/B3H) 58
12.55 Set/Read the voltage upper limit in CC mode. (B4H/B5H) 58
12.56 Set/Read the voltage lower limit in CC mode. (B6H/B7H) 58
12.57 Set/Read the current upper limit in CV mode. (B8H/B9H) 58
12.58 Set/Read the current lower limit in CV mode. (BAH/BBH) 59
12.59 Set/Read the voltage upper limit in CW mode. (BCH/BDH) 59
12.60 Set/Read the voltage lower limit in CW mode (BEH/BFH) 59
12.61 Set/Read max input resistance setting of E-load. (C0H/C1H) 59
12.62 Set/Read the voltage upper limit in CR mode. (C2H/C3H) 60
12.63 Set/Read the voltage lower limit in CR mode. (C4H/C5H) 60
12.64 Set/Read the current range in list mode. (C6H/C7H) 60
12.65 Set/Read autotest steps. (D0H/D1H) 60
12.66 Set/Read Short steps. (D2H/D3H) 61
12.67 Set/Read Pause steps. ( D4H/D5H) 61
12.68 Set/Read single-step on-load time of autotest mode. ( D6H/D7H) 61
12.69 Set/Read delay time of single-step in autotest mode. ( D8H/89H) 61
12.70 Set/Read single-step off-load time of autotest mode. (DAH/DBH) 62
12.71 Set/Read autotest stop condition. (DCH/DDH) 62
12.72 Set/Read autotest chain le. ( DEH/DFH) 62
12.73 Save/Recall autotest le. (DEH/DFH) 62
12.74 Set/Read Von mode. 0EH/0FH 63
12.75 Set/Read Von value. (10H/11H) 63
To Next Page
Loading...
Need help?
General
