33
2.7 Overcurrent Protection OCP
Press to enter the “Configuration” menu and press to enter
the PROTECTION setting screen. Then, use the knob to set OCP to ON and
press to confirm it. Now the cursor will move to the value setting for
the OCP on the right hand side. Enter the OCP value by pressing the numerical
keys.
2.8 Overpower Protection OPP
Press to enter the “Configuration” menu and press to enter
the PROTECTION setting screen. Then, use the knob to set OPP to ON and
press to confirm it. Now the cursor will move to the value setting for
the OCP on the right hand side. Enter the OPP value by pressing the numerical
keys.
2.9 Voltage Output
After the voltage, current and protection settings are entered, press
to
output voltage. User will be able to recognize the setting values and the actual
output values from the LCD.
2.10 Control Voltage Output with Rotary knob
When the output is ON, a user may still increase or decrease the output voltage
F
=
=
=
F
S
=
S
S
=
=
.
3
01
.
.
6
5 3 4
56
To Next Page
Loading...
Need help?
General
