96
Example: GOC 3.000
Sets all the power supplies’ OCP value to 3.000 A.
GOCP
Description:
Configures/Queries the overcurrent protection state
of all the power supplies connected in the chain.
Example: GOCP ON
Sets all the power supplies’ OCP state to ON.
GOP
Description:
Configures/Queries the overpower protection value
of all the power supplies connected in the chain.
Example: GOP 300.00
Sets all the power supplies’ OPP value to 300.00
W.
GOPP
Description:
Configures/Queries the overpower protection state
of all the power supplies connected in the chain.
Example: GOPP ON
Sets all the power supplies’ OPP state to ON.
4.7.4 Error List
When using any of the commands for multi-unit programming for
configuration, a response string is returned. If the command was sent
successfully to the power supply(s) (except for Synchronous Control
To Next Page
Loading...
