Bosch D7412GV4 - Page 100

100 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
Change Relay
Use this function to manually set and reset Relays 1 through 128 (1 through 64 in a D7412GV4
and 1 through 28 in a D7212GV4) that are installed in the system.
Remote Program
Use this function to start remote programming software (RPS) sessions. When the phone is
ringing at the control panel, starting this function causes the control panel to seize the line.
Move to Area
Use this function to switch the keypad’s assignment temporarily to a different area. This
command can be used to perform any function that can be performed by a keypad assigned to
the area in programming.
Users are limited to performing functions enabled by the authority level they have in the area
to which the keypad is moved. After several sec of no activity at the keypad, the keypad
reverts back to the originally programmed area.
Display Revision
Use this function to show the control panel’s software revision number in the keypad display.
Service Walk
Use this function to Walk Test all points in the entire control panel regardless of the P## Type.
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
28 Change Relays [COMMAND][5][4]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
29 Remote Programming [COMMAND][4][3]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
30 Move to Area [COMMAND][5][0]
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
32 Display Software
Revision
[COMMAND][5][9]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
33 Service Walk Test (Menu function only)
NOTICE!
The Service Walk Test is available on the D9412GV4 using the Service Menu [9][9][ENT]. The
D7412GV4 and D7212GV4 do not include the Service Walk Test in the Service Menu. In the
D7412GV4 and D7212GV4, the Service Walk Test function must be enabled in the Function
List to access the Service Walk Test.